Permanent outdoor audio that whispers — and takes the whole property when you entertain.

Yes — when the system is specified for it. We use speakers, subwoofers, and mounting hardware rated for outdoor exposure, and we select models based on how exposed each location is: a covered patio, an open pool deck, and a coastal rooftop are three different environments. Wiring, connections, and any outdoor-mounted electronics are installed and protected accordingly.

That is the point of designing it this way. We size and configure the system so it sits comfortably at conversation level for everyday listening, then still has real output and low-end in reserve when you are entertaining — rather than a small system pushed past its limits on the one night you need it most. Processing and limiting protect the equipment at either extreme.

Yes. We can build in dedicated, protected DJ and live-input connections at the locations that make sense for your property, so a DJ or band plugs into the house system instead of trucking in a full rig. Levels stay under system protection, so a guest vendor cannot damage the installation.

Yes. Wireless microphone capability can be built into the system for toasts, ceremonies, speeches, and hosted events at home. We plan frequency coordination and antenna placement around the property so coverage is reliable where you actually use it.

Yes — that is multi-zone audio. Each area can be its own zone: living areas, patio, pool deck, backyard, rooftop, courtyard, guest house, gym. Zones can run at independent levels, and depending on the design, different sources at the same time — quiet music inside while the pool deck runs the party.

Yes. Outdoor subwoofers are what separate a system that plays music outside from one that actually feels like an event. They can be surface-mounted, placed in landscaping, or built into the architecture depending on the property, and are specified for outdoor use.

Every system is custom quoted. Cost depends on property size and layout, how many speakers and subwoofers the coverage requires, the number of zones, wiring runs and how concealed they need to be, mounting and any architectural integration, the equipment selected, and installation complexity — including how much of the property is already finished. We scope the system to your property and quote it in writing rather than publishing a range that would not mean anything for your home.

Yes, and most residential work is retrofit rather than new construction. We plan wiring routes that work with finished walls, hardscape, and landscaping, and we are direct about where a run is straightforward and where it requires more invasive work. Where specialized electrical, networking, construction, engineering, or permitting work is required, projects can be coordinated with the appropriate licensed trades when required.

Both. We design the system, supply the equipment, install and route the wiring, mount and aim the speakers, build and terminate the rack, configure the processing and zones, tune the system on site, and show you how to run it. Equipment is selected from professional-grade manufacturers based on what the installation calls for — we specify to the property rather than to a brand.